Sudo apt install -y gcc g++ make build-essential sox gstreamer1.0-tools gstreamer1.0-plugins-good gstreamer1.0-plugins-base gstreamer1. Headless setup on the Raspberry Pi Zero (W) Once it’s completed, Open the boot volume on your Mac (should auto mount after the disk image is finished writing). Similarly, remove the Wi-Fi USB dongle and attach this to the Pi Zero and boot up. ![]() At the time of writing this, the version was: Edge Impulse Linux client v1.3.1 With the wireless card setup the SSID is detected, the username and password input, and the connection made you should then shutdown the Raspberry Pi, remove the microSD card and insert it into your Pi Zero. These commands replace those from the official documentation in the section 2. Install Pi OS Legacy ( buster) on the Pi Zero W board using the Raspberry Pi Imager application. It is important to connect your laptop to the. If you would like to try this for yourself see the instructions below. Go ahead and insert your micro SD card into your Raspberry Pi Zero and connect it via USB to your computer. ![]() Since the only hardware I had on hand was the Pi Zero W, I experimented for a while and managed to get it working. I wrote it as post on my wordpress site Įdge Impulse does not officially support the Raspberry Pi Zero W hardware, and if you attempt to follow the official documentation meant for installing it on an a Raspberry Pi 4, on a Pi Zero W, the installation will fail. Hi, I thought this might help anyone who wants to try Edge Impulse on a Raspberry Pi Zero W.
0 Comments
Leave a Reply. |